Artificial Grass Products :: SYNRye 150

SYNLawn Synthetic Grass Product: SYNRye 150

SYNRye 150

Price: Call

Warranty: 8 year warranty

Total weight: 67 ounces

SYNRye 150

SYNRye 150 artficial turf is the same construction and design as the SYNRye 100 with the exception of the lighter green used for the straight blades. Incorporating the tan color in the thatch makes it sure to be one of the best selling products we offer based on the historical performance of the SYNRye collection of artificial grass products.

Environment Friendly
Exclusive EnviroLoc technology with BioCel backing system results in 60%-70% green by weight with greater dimensional stability. Contributes points towards LEED certification.
No infill required
No black rubber crumb necessary. Greatly reduces maintenance of artificial turf.
Resiliency
Superior resiliency with 100% nylon fibers.
Recommended for
Residential landscapes, sloped areas, water saturated areas, pool areas and moderate to high traffic areas. Highly recommended for child play areas and pet areas.
Yarn type
  • Grass Zone: Nylon HeatBlock
  • Thatch Zone: High Bulk Texturized Nylon HeatBlock
Color
  • Grass Zone: Green
  • Thatch Zone: Green/Tan
Pile height
  • Grass Zone: 1.625"
  • Thatch Zone: 1.375"
Total weight
67 ounces
Warranty
8 year warranty year
Roll width
15.00 Feet
Drain rate
30 inches per hour
Sub-base
  1. Remove sod if necessary.
  2. Grade must be at least 3 inches below the border (curbing, edging, patio, etc.).
  3. Install at least 2-4 inches of 1/4" minus compaction aggregate (road base) bringing the grade up to 1 inch below the border.
  4. Level and disperse aggregate with landscape rake.
  5. Lightly soak the aggregate.
  6. Compact aggregate using a vibratory plate compactor. Aggregate may be added to low areas during this process.

Note: Aggregate will stick to the compactor if too wet. At least 80% compaction is ideal.

Seams
  1. Precisely cut the edge against the tufted row.
  2. When seams are in position, place a nail approximately 18 inches from the seam to secure the turf.
  3. Fold back the turf and hold with a temporary weight.
  4. Lay 12-18 inch urethane cloth directly under the seam.
  5. Secure cloth with a nail at the end of the seams.
  6. Pour and spread adhesive on the cloth. (use scrap piece to spread adhesive) Remove the weight from the folds.
  7. Slowly and simultaneously lay both sides of the turf on the adhesive. Avoid overlapping the backing. In addition, make sure the fibers do not come in contact with the adhesive.
  8. Apply weight on the seams and allow 1hour to dry. When complete, seams may be reinforced with nails.
Edges
  1. Overlap edges with turf.
  2. Secure the position of the turf with nails.
  3. As with seaming, fold back turf to the edge exposing the backside.
  4. Cut vertical relief cuts to create smaller sections to work with. On the backside, cut the excess turf precisely to the edge. Turf should be cut within 1/8 inch from the edge.
Infill
Infill not required.